upporting a large water stone up to one tonne.

• TWO SUMP SIZES

• The Finia 2000 for larger stones and groups requiring a larger splash area.

• NOW AVAILABLE THE NEW ISIS 660 PUMP,RUNS ANY SIZE WATERSTONE UP TO 11' £75,
• PIPE TO FIT PUMP AND STONE, £2 PER METRE.

• Step 1
• Make sure the hole is level and at the right depth can save a lot of time putting the Finia in and out of the hole.

• Step 2
• If the total weight of the feature exceeds 150kg, think about soil structure, will it subside over time? If you think it will add a suitable concrete base, this will save you having to re-level at a future date.

• Step 3
• After smoothing out the concrete put the Finia in and make sure it is level before the cement sets.

• Step 4
• After the concrete has set, back fill around the Finia base with soil. If the feature is over 250kg soil can be pushed into the 'fins' for additional support. For really heavy features see the Finia Moulds section for 'concreting fins'

• Step 5
• The Finia's fins being made of 100% recycled MDPE are flexible and can be lifted to gain access to the pump for maintenance. If the base of your feature is such that it is difficult , cut off one of the fins to make a removable pump hatch. This does not effect the strength of the Finia and the hatch section is sturdy enough to hold any decorative stone.

• Step 6
• When the lid is in place your chosen feature can be assembled on top. After positioning your chosen water feature turn on the pump and check the height of the water, if it too high the water will splash outside the Finia and the pump will run dry quickly.

• Step 7
• Make sure all electrical cables are adequately protected, connections are water proof and the whole electrical installation is safe. If in doubt consult a qualified electrician. Plant round the back of the feature and add decorative stones to to hide the remainder of the Finia.

The Finia Mould


The Finia water feature reservoir, through their design can support an immense amount of evenly distributed weight.

The ground however on which the feature will be situated may not be as stable. The re-useable 'Finia' concrete mould can be used to act as footings and stabilise the ground and further increase the weight tolerance of the 'Finia' water feature container.
Available to hire at Thompsons @ £20 + deposit.

• Step 1
• Dig out required depth & Diameter 'hole'. Fill base with a few centimeters of concrete. Put reusable mould in 'hole' and ensure all is level. Fill support 'fins' with concrete.

• Step 2
• When set, remove mould (Mould can be used again and again).

• Step 3
• Replace with 'Finia' water feature reservoir and assemble your chosen water feature.

ANOTHER FINISHED FEATURE!